2003 bmw 325i fuse box location

Where is the fuse box on a e46 BMW?

glove compartment

How do you check a BMW fuse?

Fuses are located behind the glove box on the dashboard. To access the fuses on a BMW 3-series, open the passenger door. Open the glove box. You will see two plastic round screws.

Where is the fuel pump relay on a 2002 BMW 325i?

I can now confirm that on the 2002 325i , the fuel pump relay is behind the glove box. It’s the first relay in the row of four relays at the top.

Where is the fuel pump relay located on a BMW e46?

It’s behind the glove box.

How do you tell if a fuse is blown?

Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.

Where is the fuse box BMW 3 Series?

Fuse Box Location It is located on the right side of the engine compartment (on the left side on the right-hand drive vehicles), under the plastic cover.

Can a blown fuse prevent car from starting?

Usually, a blown fuse just causes a minor car electrical problem, like backup lights or interior lights not working, not being able to use your radio, losing a turn signal, or some of your climate control features not functioning properly. In rare cases, though, a blown fuse can mean that your car won’t start .

How do I know if my fuel pump or relay is bad?

Usually a bad or failing fuel pump relay will produce a few symptoms that can alert the driver of the issues. Engine stalls. One of the first symptoms of an issue with the fuel pump relay is an engine that suddenly stalls. Engine does not start. No noise from the fuel pump .

You might be interested:  What coolant for bmw

How do you test a fuel pump relay?

How to test a fuel pump relay Park the car in safe and level ground. Step 2: Turn the ignition key in the ON position but don’t start the car. Step 3: Raise the hood and locate the fuel pump relay . Step 4: The fuel pump relay will emit a clicking or buzzing sound when turning the key in the ON position.

How do you test a relay?

The only tool required to check a relay is a multimeter. With the relay removed from the fuse box, the multimeter set to measure DC voltage and the switch in the cab activated, first check to see if there are 12 volts at the 85 position in the fuse box where the relay plugs in (or wherever the relay is located).

Leave a Reply

Your email address will not be published. Required fields are marked *