Bmw radio no sound

Why is my radio on but no sound?

If the amp fuse is blown, that is probably the reason that you aren’t getting any sound out of your car radio . In some cases, a broken wire or bad connection in the speaker wires where they pass through into a door can also cut off the sound altogether rather than just cutting off the sound to one speaker.

How do I reset my BMW radio?

How to Fix a Disabled BMW Radio Locate the vehicle’s personalized radio code in the car’s manual. Place the key into the ignition and turn the vehicle on. Use the station preset buttons to enter the radio code into the system and press and hold the “Volume” button to complete the code.

Why does my BMW radio keep cutting out?

A fairly common cause of the radio turning itself off after a couple minutes is a faulty NAV computer. The NAV computer is subject to failure when the battery is disconnected before it fully spins down (light goes off).

Is there a fuse for radio sound?

A car radio will have at least one fuse to protect the unit from things like power surges or other electrical issues. If too much current is sent to the audio system, this fuse will blow out and disconnect the circuit to save the main radio . On newer models, there are a variety of fuses for the entertainment system.

Why is my car audio not working?

Blown Fuse: One of the most common reasons for a car radio to stop working is a blown fuse. If the radio itself will not turn on, chances are good that there’s one or more blown fuses causing the problem. A damaged antenna means that your radio isn’t able to receive signal from stations.

You might be interested:  2000 bmw 528 specs

How do I reset the radio Wait code on my BMW?

1996 BMW Stereo CODE WAIT Disconnect the Battery to reset the computer again. Leave the car in the “ON” position for 90 Minutes and the radio will reset and ” CODE ” will appear. If the radio is in the ” CODE ” mode awaiting you to enter a 5 digit code you can hold in your “M” button and it will display the S/N of the radio .

How do I reset my BMW after changing the battery?

You need to press and hold the “Trip” button on the instrument panel until the red light comes on. Next, press the Trip button a second time and then hold until Reset appears. After which, press the Trip button a third time. Then, the BMW computer is now reset .

How do I reset my BMW ECU?

How to Reset a BMW Computer Turn your ignition key to the accessory position when the lights and radio come on (before starting the car). Press and hold the “Trip” button on the instrument panel until the red light comes on. Press the “Trip” button a second time and hold until ” Reset ” appears. Press the “Trip” button a third time.

How do I turn off the radio when my BMW is off?

The answer to your issue is 1) keep the engine running or 2) press the start button again with your foot off the break and your radio can keep playing.

Leave a Reply

Your email address will not be published. Required fields are marked *